ENUM MAC80211_RX_FLA(9) The basic mac80211 driver inte ENUM MAC80211_RX_FLA(9)

NAME enum_mac80211_rx_flags - receive flags

SYNOPSIS enum mac80211_rx_flags { RX_FLAG_MMIC_ERROR, RX_FLAG_DECRYPTED, RX_FLAG_MMIC_STRIPPED, RX_FLAG_IV_STRIPPED, RX_FLAG_FAILED_FCS_CRC, RX_FLAG_FAILED_PLCP_CRC, RX_FLAG_MACTIME_START, RX_FLAG_SHORTPRE, RX_FLAG_HT, RX_FLAG_40MHZ, RX_FLAG_SHORT_GI, RX_FLAG_NO_SIGNAL_VAL, RX_FLAG_HT_GF, RX_FLAG_AMPDU_DETAILS, RX_FLAG_AMPDU_REPORT_ZEROLEN, RX_FLAG_AMPDU_IS_ZEROLEN, RX_FLAG_AMPDU_LAST_KNOWN, RX_FLAG_AMPDU_IS_LAST, RX_FLAG_AMPDU_DELIM_CRC_ERROR, RX_FLAG_AMPDU_DELIM_CRC_KNOWN, RX_FLAG_MACTIME_END, RX_FLAG_VHT, RX_FLAG_80MHZ, RX_FLAG_80P80MHZ, RX_FLAG_160MHZ };

CONSTANTS RX_FLAG_MMIC_ERROR Michael MIC error was reported on this frame. Use together with RX_FLAG_MMIC_STRIPPED.

RX_FLAG_DECRYPTED This frame was decrypted in hardware.

RX_FLAG_MMIC_STRIPPED the Michael MIC is stripped off this frame, verification has been done by the hardware.

RX_FLAG_IV_STRIPPED The IV/ICV are stripped from this frame. If this flag is set, the stack cannot do any replay detection hence the driver or hardware will have to do that.

RX_FLAG_FAILED_FCS_CRC Set this flag if the FCS check failed on the frame.

RX_FLAG_FAILED_PLCP_CRC Set this flag if the PCLP check failed on the frame.

RX_FLAG_MACTIME_START The timestamp passed in the RX status (mactime field) is valid and contains the time the first symbol of the MPDU was received. This is useful in monitor mode and for proper IBSS merging.

RX_FLAG_SHORTPRE Short preamble was used for this frame

RX_FLAG_HT HT MCS was used and rate_idx is MCS index

RX_FLAG_40MHZ HT40 (40 MHz) was used

RX_FLAG_SHORT_GI Short guard interval was used

RX_FLAG_NO_SIGNAL_VAL The signal strength value is not present. Valid only for data frames (mainly A-MPDU)

RX_FLAG_HT_GF This frame was received in a HT-greenfield transmission, if the driver fills this value it should add IEEE80211_RADIOTAP_MCS_HAVE_FMT to hw.radiotap_mcs_details to advertise that fact

RX_FLAG_AMPDU_DETAILS A-MPDU details are known, in particular the reference number (ampdu_reference) must be populated and be a distinct number for each A-MPDU

RX_FLAG_AMPDU_REPORT_ZEROLEN driver reports 0-length subframes

RX_FLAG_AMPDU_IS_ZEROLEN This is a zero-length subframe, for monitoring purposes only

RX_FLAG_AMPDU_LAST_KNOWN last subframe is known, should be set on all subframes of a single A-MPDU

RX_FLAG_AMPDU_IS_LAST this subframe is the last subframe of the A-MPDU

RX_FLAG_AMPDU_DELIM_CRC_ERROR A delimiter CRC error has been detected on this subframe

RX_FLAG_AMPDU_DELIM_CRC_KNOWN The delimiter CRC field is known (the CRC is stored in the ampdu_delimiter_crc field)

RX_FLAG_MACTIME_END The timestamp passed in the RX status (mactime field) is valid and contains the time the last symbol of the MPDU (including FCS) was received.

RX_FLAG_VHT VHT MCS was used and rate_index is MCS index

RX_FLAG_80MHZ 80 MHz was used

RX_FLAG_80P80MHZ 80+80 MHz was used

RX_FLAG_160MHZ 160 MHz was used

DESCRIPTION These flags are used with the flag member of struct ieee80211_rx_status.

AUTHOR Johannes Berg <johannes@sipsolutions.net> Author.

COPYRIGHT Kernel Hackers Manual 2.6. November 2013 ENUM MAC80211_RX_FLA(9)